Also make sure to install the option to add Python to the system path so you can easily call the Python interpretor from a command terminal. Install Python into its standard location, typically C:\python27. You can download the latest Python 2.7 installer here (at the time of writing it's version 2.7.8, but any 2.7.x version should work-unfortunately the 3.x series isn't supported yet).ĭownload the MSI installer for your version of Windows, you must install the 32-bit version, and run the installer. If you want to disable MPSSE mode and enable the serial UART again I'll show instructions at the end of the page.įirst before you get started make sure you have Python 2.7 installed. Note: When you enable MPSSE mode the serial UART driver will be disabled. Carefully follow the steps below to setup the software. Finally we'll install the Adafruit Python GPIO library. Then we'll download a libftdi binary and install it for Python to access. We'll use a tool called Zadig to replace the FTDI driver for the FT232H with a libusb-based driver required by libftdi. To access the MPSSE mode of the FT232H on Windows we need to install special drivers and software.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |